Attribute Value is not Getting updated Via Quality Order

(2) Share

Report

Posted on by Enthusiast_VS

Hello Experts,

Am trying to complete the Quality order where the attribut value is not getting upated on the batch number and the error is Inventory Batch Attribute for the inventory Batch have not been updated .Attribute value fon the inventory batch exists.

Note- Item Sampling is toggleds as per batch and without both ways have tried it .

During the Purchase Registeration batch number is being selected and the Quality order is getting generated . In Quality setup upate attribute is marked as yes then also facing the error.

Appreciate if anyone had faced the same and was able to resolve the issue or anyone know on this for solution kindly help on this.

Thanks in advance.

Vivek

Categories:

Dynamics 365 Supply Chain Management

I have the same question (0)

All responses (1)

Answers (0)

Suggested answer

Fasih 414 on at

Like (0)

Report

Attribute Value is not Getting updated Via Quality Order

To address the issue, first, ensure your configurations and process are set up correctly. Start by navigating to Inventory Management > Quality Management > Quality Associations and check if the Update batch attribute option is enabled. Then, verify the attribute setup by going to Inventory Management > Setup > Batch Attributes. Make sure the required attribute is assigned to the batch, properly linked to the item, and free of any conflicting rules. For sampling, revisit your configuration in the Quality Setup section, ensuring it matches your process requirements. Toggle the Sampling by Batch option off and back on to refresh the settings, then regenerate the Quality Order. Finally, follow these steps in order: register the batch number during the purchase receipt, generate and process the Quality Order, record the results, and complete the Quality Order. These actions should help you resolve the attribute update issue efficiently.

Was this reply helpful? Yes No