web
You’re offline. This is a read only version of the page.
close
Skip to main content

Announcements

No record found.

Community site session details

Community site session details

Session Id :
Dynamics 365 Community / Forums / Supply chain | Supply Chain Management, Commerce / Error while running MR...
Supply chain | Supply Chain Management, Commerce
Unanswered

Error while running MRP for batch enabled items

(2) ShareShare
ReportReport
Posted on by CU04051032-0 25

We have the following scenario:

  1. WMS-enabled items are assigned a Batch first inventory model group, whereby the system reserves the sales order quantity from a single batch.

  2. To support this, Coverage plan by dimension is set to Yes for the Batch tracking dimension.

  3. Item coverage is configured for these batch-enabled items using a Min/Max replenishment method.

  4. However, when running Master Planning, we encounter a dimension not found error which goes away when we disable the setup mentioned in Point 2. Since item coverage cannot be defined for a specific batch, we are unable to provide a batch value in the coverage setup.

Could you please advise on how this situation should be handled?

Categories:
Dynamics 365 Supply Chain Management
I have the same question (0)
  • Laurens vd Tang Profile Picture
    Laurens vd Tang 4,394 Super User 2026 Season 1 on at
    Good day,
     
    Could you share a bit more about the business requirement and scenario?
     
    Thanks in advance!
     
    Best regards,
    Laurens van der Tang
  • CU04051032-0 Profile Picture
    CU04051032-0 25 on at
    Sure Laurens van der Tang

    We have few batch enabled items which will be reserved and released following the "Batch first" principle. 

    In addition to that we have an Item coverage setup (using Min/Max) for those items setup for generating planned PO and planned production orders.

    But when we run the Master planning based on the Min/Max principle, it throws the inventory dimension error which states it’s looking for a batch to run the master planning for those items.
     
    We want a workaround or any setup that can be configured to handled both the scenarios.
     
    Let me know if you need anything specific to be clarified. 
     
    NOTE: All as-is setups are shared in the screenshots in the post above (for reference).

Under review

Thank you for your reply! To ensure a great experience for everyone, your content is awaiting approval by our Community Managers. Please check back later.

Helpful resources

Quick Links

Introducing the 2026 Season 1 community Super Users

Congratulations to our 2026 Super Stars!

Congratulations to our 2025 Community Spotlights

Thanks to all of our 2025 Community Spotlight stars!

Congratulations to the January Top 10 Community Leaders

These are the community rock stars!

Leaderboard > Supply chain | Supply Chain Management, Commerce

#1
Mallesh Deshapaga Profile Picture

Mallesh Deshapaga 1,089

#2
Laurens vd Tang Profile Picture

Laurens vd Tang 193 Super User 2026 Season 1

#3
André Arnaud de Calavon Profile Picture

André Arnaud de Cal... 154 Super User 2026 Season 1

Last 30 days Overall leaderboard

Featured topics

Quality order uses default receipt location instead of actual physical receipt location

Product updates

Dynamics 365 release plans